JB4 Mobile Troubleshooting

1) Ensure the Connect Kit is as far away from nearby batteries/metals as possible as that can cause interference. You can also try standing directly next to the kit while attempting to connect. If standing closer to the kit RESOLVES the issue, email us at support@jb4connectkit.com and let us know you've performed the diagnostic steps already as this may indicate a range issue with your kit.

2) If you changed the PIN from the default '1234', ensure you've updated the 'Default PIN' field with the new PIN you set. If you didn't change the PIN, email into support@jb4connectkit.com. Include a screenshot of the error and let us know your username in JB4 Mobile.


Screenshot the error and email it to support@jb4connectkit.com.


1) Disable BT and wifi, restart device, enable BT, try again.

2) Check Connect Kit installation. Ensure positap is making a solid connection and that the DB9 connector is secured. Verify the voltage at the positap using a multimeter. Ensure the Connect Kit is as far away from nearby batteries/metals as possible as that can cause interference.

3) Try connecting from another phone/tablet to ensure it isn't an issue with your device. If you still have an error with another device, email into support@jb4connectkit.com and let us know you've performed all troubleshooting steps.


Try disconnecting then reconnecting the DB9 connector. If that doesn't work it's either an issue with the Connect Kit or a problem with the JB4 Master Chip. In order to test this you'll need access to another Connect Kit or BMS Data Cable. If you're unable to find either of these you're welcome to send your kit in for diagnostics. Email into support@jb4connectkit.com and let us know you're interested in having your kit tested and you've already performed the apporpriate diagnostic steps.

You'll need to include a copy of your original purchase receipt for the Connect Kit.


There is an issue with your OBDII/CANbus wire installation. For further assistance, email support@burgertuning.com.

VW Passat/Jetta Owners - Set FUD to 1 as a test


1) Attach the OTG cable (*by itself) to your device then attach the BMS Data cable and try connecting again.

2) Download USB Device Info from the Play Store.
Open that app.
Connect the cable.
Does that app show anything connected?

If not, then there is an issue with your device, OTG cable, or BMS Data cable. If something does appear and you still have issues in JB4 Mobile, email into support@jb4connectkit.com and let us know you've performed the diagnostics for this specific error message.


1) Ensure the Connect Kit is as far away from nearby batteries/metals as possible as that can cause interference. You can also try standing directly next to the kit while attempting the update. Increasing the upload timeout to say 25 may also help.

2) If you still can't get the update to take, TEMPORARILY move the Connect Kit's power wire to 12V and try the update a few more times. After the update takes, move the Connect Kit's power wire back to the correct power source for your vehicle.